406oc.co.uk

Hi fellas

I am having trouble with my Galletto software and was wondering if anyone could help at all

I try to read the ecu data but keep getting the same error message
Erroredata0
Followed by a pop up turn ignition of for 10 secs and retry

Does anyone know what might be wrong


Thanks

hi folks

as the title says does anyone have galletto near Middlesbrough.
I have a file I want writing to my car if anyone can help me out

thanks

ive checked the restrictors and cleaned them out
so i know there clean

how would i know if its a faulty injector?

Well im tempted to put the original map on my car and see how she runs

the swirl actuator is brand new i just replaced it about 2 weeks ago

the next on my list the EVs and ill see if it helps

thanks

Ive replaced all the vacuum pipes and simplified my vacuum system

ive also checked the turbo vanes which are fine and move freely

Right so im still having this issue, im driving on the moterway put my foot down and after about 5 secs it goes in limp mode. turn the car off for 15 secs and start again and all is fine till i do the same thing on the motorway. It has got me really baffled as it never cuts out at full throttle in 1...

Yes the car is remapped and defapped
Ive had new swirl diaphram on and cleaned the vnt turbo
And no i do not have access to peugeot planet

hi fellas as the title says my car goes into limp mode on the motorway at high speed.
does not doit around town or in low gears which is why im confused

has anyone had this before or knows of the cause

thanks

hi mate thanks for that response. i have allready simplified the vacuum system to a how to guide on the coupe forum thanks to finchy. but it still has some faults. i took a fresh read of the car today and the following fault codes popped up p1435 additive system p1442 additive quantity p0403 exhaust...

are you brave enough to flash the ecu yourself, or know someone who you would trust to do it for you?


what do I need to flash the ecu how hard is it to do, I have ktag (kessv2) software I can use to read the ecu if that is of any use

thanks for the reply doggy right the codes I mentioned first were before the remap, I did all the work like removed the egr etc and followed finchys guide on how to simplify the vacuum system. I will have read the new fault codes today and find out for definite what is going on, but my suspicion is ...

Thanks for the reply Right I have done the egr delete and removed any redundant vacuum pipes I have also replaced the swirl diaphragm Yes the car has been mapped but now sure if it has been done correctly The car still has the eml light on and still goes in limp mode What can I do to fix the problem...

Ok mate cheers

hi guys as the title says im in need of a good condition Sat nav MFD as mine has the dreaded lines and is unreadable