406oc.co.uk

[emoji106]. Hi


Sent from my iPhone using Tapatalk

I know it's now a bit late. But I'm sure on the 406 you could just change the abs ring, you had to heat them up to get them on. Sure I did on mine years ago. It was a late one though 53 reg.


Sent from my iPhone using Tapatalk

thanks steve. Put WD-40 every where last night. Get in this morning, just the same. Cock! It doesn't have a ram, not that you can see anyway, pipes go straight into to rack. Must be all internal.

Thanks for reply. thought about the struts and the u/v joint. but because it worked for 3 weeks or so after fluid change have sort of ruled those out. also when i had both front wheels off the ground you could still feel the resistance even with the engine off. after i drained the fluid tried the sa...

I need help with this. It's doing my head-in. got a 406 se est, 110 hdi. on 53. about 3 mounths age the power steering started acting up, I could turn the wheel so far (about quarter turn or so, either way) then it would get very heavy (no power steering) then if i turned through the heavy bit it wo...

has the car ever been jump started? also check to make sure that the correct amp fuse is in place for the ecu has been jump started a few times. but not for a while. worked for ages after last jump start. Fuses all ok. I am guessing it has the right fuse. had car from new and i have never changed a...

Update: It's Fixed, It's ****ing FIXED. Was just rereading the posts, James (canyondust) over on tdocuk.com said that the MAF was only directly connected to the ECU. So I thought for one last dich attemt would take ECU to bits. There it was a burnt out circuit, burnt all the way down the pcb. So hav...

Right. Tested the 5v Idea, All fine with MAF unpluged. But When I pluged the MAF in the voltages went up to about 12v.

Now answer me that one - I am totaly PETE TONGed.

sounds more like a throttle potentiometer fault, clear the codes, then with the ignition off unplug the maf, start the car and see how it drives then check the faults The throttle potentiometer fault and system voltage fault are only there when i plug the MAF sensor in. with it unpluged all works f...

Thats with both - just the same with both MAF's.
I just want this sorted I am sick of following all the sunday drivers, go faster following a bloody tractor.

Borrowed a friends code reader today - it's a 'memoscan U581 not sure how good it is. got something funny (I think - Not that up on electronic side) I cleared all the codes first, then when i check again with the MAF sensor unpluged i only get 2 codes - P0190 Fuel rail preasure sensor circuit Malfun...

Have got a 406 110 HDI, D9 (I think - on 53 plate - if that helps) it was a bit slow at bottom end, after searching this (and other sites) found out was probably MAF sensor. Got a scrap joby (all numbers matched so think its the right one). thats when it went tits up. Fitted new one no bother. but w...