406oc.co.uk

(old school of thought) The 3 relays on fan control centre one 5 pin change over relay. Left fan relay (low speed) right fan relay (high speed) these relays are earthed via terminal 2 on relay to cooling fan control unit. i would imagine you have a control unit fault or wiring. Just a few basic' che...

406 2.1 1997 This car drives 100% but just recently has developed a intermittant fault. Some times when your driving car just cuts out for no apparent reason starts to chug a bit before cutting out. will re- start again with key no problem. Took car to main peugeot dealers to-day for a code read cam...

I;m trying to source as/hand ecu for a 307 hdi 2l eng code dw10 ated (rhs) after paying out £480 for a botched repair. I'm trying to cut my loses and opt for a s/hand one +bsi box +key the 2l 110 bhp are like hens teeth to get. browsing through auto data the 406 hdi rhs system 110bhp 3 plug ecu wiri...

The sun roof is not working on this vehicle checked for voltage at switch with ignition on today checked all fuse's all okay maybe engine has to be running for voliage at switch can any body shed sny light on this wirnig diagran !fuse location any feedback greatly appreciated best regard's mickey bo...

Posted Today @ 22:10:04 faulty ecu Saturday Job Group: Forum Members Last Login: Today @ 23:09:13 Posts: 24, Visits: 542 Posted: Sat Jan 30, 2010 8:26 pm Post subject: faulty ecu unit on 307 2.0l hdi 02 eng code rhs -------------------------------------------------------------------------------- At ...

This 307 was code read at main Peugeot Dealers, A few faults were found exhaust pressure sensor down stream gas tempature sensor these were fitted at the time, most recently started going into limp mode again exchangeed (MAF) sensor with a know'n good one but to no avail on doing some checking using...

The heater blower motor is not working on this vehicle with ign on getting battery voltage at red wire at blower motor with engine idling voltage at blower motor falls to zero volts. This vehicle has A/C. Does anyone know of issues with this particular problem. Any feed back greatly accepted best Re...

According to data i have there are two different part no's for turbo's on this 307 (garret gt 15) (kkk 03) these two part no'sare also listed for 406 engine Dw 10. I have been informed as long as it's out of a 110 bhp model it will fit straight in. Does anyone know which eng code for the 110 bhp mod...

is your 406 a 2l or a 2.2l has it got exhaust fap filter fitted what is the
present milage. assuming it has exhaust fap filter fitted if so would be
most likely cause of limp mode more info required
best reguards Mickey bo

this vehicle was left with us to day because of anti pollution fault and eng management light on intermittent fault. Our hand held code readers does not cover this vehicle but on desiding to do some checking ourselves. We found egr solonid valve faulty does any 1 know would this in its self cause a ...

remove multi plug from sensor and check for approx 5volts with multimeter if voltage is within these limits replace multi-plug back probe plug ign on if coolant sensor ok you will get a voltage reading of approx 3.4 volts keep multimeter connected start engine as engine warms up voltage will drop to...