406oc.co.uk

thanks Doggy well got the swirl thingy changed after gouging both hands and removing all the things U mentioned plus a few more, but to my dismay it made little change to the preformance . so I thought it over in my dreams and came up with a good Idea, well actually remembered what exboyracer said t...

did you look at all your fuel lines for leaks , where air is leaking in fuel will more than likely be leaking out. at the very high pressure the fuel is pumped to, I wouldn't think air bubbles would make any difference . get pp2000 to read your fuel pressure .

great day today , got a new swirl diaphram and fit it , what a job , Pug don't seem to put any design thought into repair or replaceing . I also tried to take off the EGR system but just could not get the two screws out which hold it on. I wonder if it could be got with an impact driver from below ?...

well checked the vac pressure today and off the pump it was 800 mbar , then checked it at the turbo ev and found it down at 100, so after further checking found that the swirl diaphram is leaking pulling the whole system down . so will get a new one and that should be the end of it , hopefully there...

both pp2000 and Pug service box say my coupe 2.2 hdi has variable power steering . what does it do ? or what difference is there to the action of steering ?

ah interesting you mention the brake servo , because everytime the engine fault lite comes on so does the triangle esp abs fault lite. It says something like esp abs system disconnected or turned off and then after awhile of driving it goes away. My earlier thinking was that it must be something to ...

Hi Doggy: thanks for your thoughts , yes I have read exboyracer's Hdi guide its a good piece of work very helpful. and I have checked the entire vac system all the pipes and all the joints and all the valves only thing I didn't ake off the car was the egr and turbo actuators, because of there very d...

This turbo pressure fault is very hard to find. It is an imtermittent fault and I also get P2035 Turbo press. signal short circuit to positive or open circuit , value to high Is the turbo pressure measured by the map sensor? When this fault is active the car has no power it doesn't matter where you ...

ya the glow plug light only comes on for a few seconds , but depending on the conditions , like temp, they stay on for so many seconds.
try this link http://public.servicebox.peugeot.com/ and look for the users manual or if you have one have a read.

Hello : I have been reading the info here about this Po245 fault hi turbo press. I have found one vacumm ev valve leaking , it didn't close at all, replaced that . then I fixed the leaks in the inter cooler pipes . One was a crack in the plastic pipe under the engine and the other was the exit joint...

Thanks Doggy and steve_
It is raining heavy right now but as soon as it quits , I'm out to the car .

I am baffled I can't find this relay it is not where other posts say it is .
I have an 03 2.2 406 coupe . Peugeot service box show ti but they don't say were it is.
does anyone know????

thanks for the replies, I was thinking the same , that there would be some of this oil collection. But I have washed off the leakage at the connection front right of radiator twice and only done 800 miles , so I am wondering if the plastic couplings of the intercooler/radiator may be cracked . Ah it...

I have a 2.2 hdi 03 coupe and have fluid leaking out of the intercooler piping and when I took the trottle body out and checked the inlet manifold it was coated with a tar like substance , very thick and gooy. when I further dissassembled the piping it was everywhere but thinner as I got farther awa...

Thanks dogslife that has me started