406oc.co.uk

I just bought Clarion Pu-2184A head unit to replace my old Philips head unit. there is standard Philips 6-disc changer on the boot. will they fit if I connect the Philips 6-disc changer? If they aren't...is it possible to connect aftermarket Clarion 6-disc changer?what type? because the Genuine Clar...

thanks a lot Steve finally my "one touch" is working again. the problem was inside regulator motor. there is a module/control unit contains IC and relay. Fortunately, not IC or relay was bad, but one track on pcb which burnt/disconnected. sorry I didn't take a lot pictures. but, get your window reg ...

If I'm not mistaken, the function of "one touch/automatic" is controlled by the front driver side's motor (6032 on sedre)?
not by the driver's side switch itself (6036)?

I'm right?

Hi, my driver's side electric windows "one touch" not function. I have tried swapping the switch, and there is no problem with the switch. Can someone give me schematic wiring diagram for D9's electric windows? I think 1999-2002 Hayness Manual forget to put electric windows wiring diagram :lol: sorr...

sunvisors with lights?
headlight jetwasher(include cover, bottle, and pump)
interested if can post to Indonesia and at reasonable price

anyone can PM me what's the instruction how to repair them?

Thanks.

Make sure you are in the replacement parts section. Look for an option for radio controls by wire or by van bus - select wire for the thin stalk an van forthe thick stalk yes, I have choosen the van bus next, I go to test by ECU -> Radio -> fault reading -> "Remote intermittent fault. No Communicat...

very simple - go into replacement parts and configre it from there I have tried configure it. when I go to MFD menu -> next -> it list MFD part numbers and asked am I on that list -> ok -> no cummunication ? go to control under steering wheel I see that "Radio Stalk*" there is " * " but when I pres...

bump....

any idea how to config after replacing MFD/radio stalk through PP2000?

thanks.

allright

I will try configuration with PP2000
of course after I finish struggling installing PP2000.
got 3 set chinesse lexia 3, nothing working at all. don't know what's the problem.
have tried a lot of manner, fresh copy winXP, different NB, different car, different software

any updated to resolve this problem? I have the same problem, PP2000 can't communicate with the vehicles. after enter build code, it always shown messages "switch on ignition" and "connect portable to connector 001" if I do global test, all the ecus not replied and the grey screen. I bought 3 set of...

I found when changing from a Type b (two button) screen to the type c (sat nav) screen that the stalks did not respond and the pp2000 was needed to change the settings, but i don't think if you replace a B screen with another B screen that it would cause such an issue the problem is from type B (20...

hello all

I notice my radio stalk stop function after I replace faulty MFD.
and I have thrown the faulty one

I think all D9 MFD are same...but they are not.

anyone know what should I do?can PP2000 restore my radio stalk function?
it's 2004 D9 full mux.

thank you.

weak fuel pump I think.

weak fuel pump I think.....
not related, but happen at the same time.