406oc.co.uk

Not sure when I became so obsessed with pressures and condition of tyre's, but it is not a bad thing, I also only check them early in the morn before the sun starts to increase the pressures.. Out here in the hot sunshine, they can differ by 10 psi from sun to shade... Always makes me wonder about p...

Possibly Diesel fungus / microbes, Used to get it on Marine diesels when I was in the trade, Try searching google for it

Steve

Tyre Pressure gauges My favourite subject, I have to admit I am OCD on tyre pressures, I have at least 6 pressure gauges and usually check all of mine on a Saturday morn if not away working. Wife thinks I am a bit crazy I check 2 cars, including spares 2 motorcycles 2 cycles 1 ride on mower 2 wheel ...

That looks almost as big as my truck...Looks good on inside, You must need an HGV licence to drive it

I don't know what the readings should be,I use a different Diagnostic system and don't have any fault codes on, but I occasionally pull my MAF sensor out and give it a clean with solvent spray and airline, It doesn't do it any harm, Mine is on original MAF with 274000 miles on it.

Cant get the hang of adding photos,
It makes my trailer look a bit small

Its not bad, A dream to drive and just enough room for 2 weeks away, That was a rather wide one from the ABI factory near Beverley UK, to just south of Calais, It was 4.76 metres wide, most of them I move are around 4 metres

I see all the crap driving while out delivering these, Its amazing how many drivers dont see me coming till last minute or risk themselves pulling out in front of me.

Makes for an interesting ride

You could try this mod

Max and Min on stick are just that. I always like to run mine a few mm below max. Many many years ago I was a powerboat mechanic, and due to different angles of engine installation or operating conditions we found that in severe cases with a very full sump the crank would splash in the oil, causing ...

Some of you guys are far to clever. You make the rest of us look like numptys..

Get a good quality one fitted, The cheap versions dont last

Easy job yourself if you handy with the tools, All the info you need via this site

Possibly crankshaft pulley failing

I think the overhaul kit was about 25 quid, with all the seals and rubbers etc for 2 callipers

Used these for seal kits, Good stuff right price

http://www.biggred.co.uk/