thanks ...Robrough idling
Moderator: Moderators
rough idling
My 2 litre petrol 16 valve engine is running rough, erratic idling and stalling when I stop .I have cleaned the stepper motor but it has made it worse anyone any ideas thanks ...Rob
thanks ...Rob1997 406 2.0 petrol estate lx..D8.............OH dear where does this nut go?
-
teamster1975
- Site Admin & Mad Biker!
- Posts: 6277
- Joined: Sun Oct 28, 2007 8:07 pm
- Location: Woking, Surrey
Re: rough idling
Unplug the stepper and see if the idling goes any rougher. If it doesn't change then it may well be sh@gged.
Failing that you could check the MAP sensor & Lambda sensor
Failing that you could check the MAP sensor & Lambda sensor
1996 406 1.8LX Got a bad case of hydro lock!
1996 406 Executive 2.0 Turbo XU10J2TE No longer hangin' on in there
1997 Honda CB500V
2003 Volvo V40 1.8 GDi SE killed by a nutter in a beemer 5 series
2008 Mondeo 2.0 TDCi Titanium X
"Always look on the bright side of life, dedo, dedo dedodedo"
1996 406 Executive 2.0 Turbo XU10J2TE No longer hangin' on in there
1997 Honda CB500V
2003 Volvo V40 1.8 GDi SE killed by a nutter in a beemer 5 series
2008 Mondeo 2.0 TDCi Titanium X
"Always look on the bright side of life, dedo, dedo dedodedo"
Re: rough idling
Thanks Teamster will try tomorrow ...Rob
1997 406 2.0 petrol estate lx..D8.............OH dear where does this nut go?
Re: rough idling
Update took connections off stepper motor, and sprayed with some electric and degreaser spray Touch wood no more rough idling for three days
1997 406 2.0 petrol estate lx..D8.............OH dear where does this nut go?
-
ddoherty406
- 2.0 16v
- Posts: 112
- Joined: Sat Jun 07, 2008 5:36 pm
- Location: Derry, Northern Ireland
Re: rough idling
Hows it goin. I had the same problem and i think ive finally sorted it. Mine started playing up after it went for the mot wash. I tried cleaning out the stepper motor but this seemed to make it worse. At one stage it was sticking all the way out and wasnt alloying the car to start. I then replaced it for one I got in the breakers (£5 bargin, pug stealers wanted £90 for a new one. 
) I cleaned out this one with wd40. I also cleaned the throttle body where the stepper motor goes into also. This sorted the erratic idle however as soon as the car got up to temperature it started playing up again. I decided i mite as well take the whole throttle body off and give it a good clean. In the process i took off the yellow sensor thats on the top (i assume this is a temp sensor) to my suprise and a little bit of relief it was covered in limescale. I simply cleaned off the crud from the sensor and the hole where it sits. I then gave the throttle body another clean and but everything back together and resyncronised it. Its now running grand. Hope this helps you.
) I cleaned out this one with wd40. I also cleaned the throttle body where the stepper motor goes into also. This sorted the erratic idle however as soon as the car got up to temperature it started playing up again. I decided i mite as well take the whole throttle body off and give it a good clean. In the process i took off the yellow sensor thats on the top (i assume this is a temp sensor) to my suprise and a little bit of relief it was covered in limescale. I simply cleaned off the crud from the sensor and the hole where it sits. I then gave the throttle body another clean and but everything back together and resyncronised it. Its now running grand. Hope this helps you.
Re: rough idling
Thanks DD I have not had the problem since I took off the connector wires and gave them squirt of cleaner stuff I got off a plant mechanic I know .If I do I will try your tip
1997 406 2.0 petrol estate lx..D8.............OH dear where does this nut go?
Re: rough idling
I have quite an uneven lumpy idle on my 2.2 petrol. I also have a constant engine management light on. I got it checked at the garage while it had its mot and he cleared it. The lambada sensor was couple of the entries so not sure if it needs replacing or something else? Anyhow the engine management light came back on after about 5 miles and has stayed on 6 weeks now.
May have to get it read again and see if it is the lambad still I suppose.
May have to get it read again and see if it is the lambad still I suppose.