Exhaust Rattle

Discuss, ask, or get help with engine and mechanical queries in here.

Moderator: Moderators

Post Reply
saltyseadog
Newbie
Posts: 3
Joined: Sun Sep 12, 2010 4:54 pm

Exhaust Rattle

Post by saltyseadog »

Hi everyone, new to the forum and new to 406's too.

I own an R reg 1.9td lx. It's pretty high mileage, 234000 to be precise, it goes well. Fuel economy pretty good as well.

A couple of niggles.

1. It sounds like the exhaust is lose, I put the car on the ramps and had a prod with a stick (I'm very technical :cheesy: ) and the rattle stops, as it does when the engine is under load.
is this manifold/heatshield related? I also noticed between the manifold and the metal "u" shaped mount at the rear of the exhaust there is no other mounting point, is this usual?

2. when its cold and I turn the wheel hard it squeals, not unlike a fan belt squeal , when the car is warm the squeal goes away.

Thanks in advance :)
98 406 1.9td lx 234000 Genuine Miles :)
teamster1975
Site Admin & Mad Biker!
Posts: 6277
Joined: Sun Oct 28, 2007 8:07 pm
Location: Woking, Surrey

Re: Exhaust Rattle

Post by teamster1975 »

Welcome in seadog! :)

1. Could be one of the rubbers has gone or the flexible connector is knackered. Is it blowing?
2. Auxilliary belt loose, unless PAS pump is getting tired.
1996 406 1.8LX Got a bad case of hydro lock!
1996 406 Executive 2.0 Turbo XU10J2TE No longer hangin' on in there :(
1997 Honda CB500V
2003 Volvo V40 1.8 GDi SE killed by a nutter in a beemer 5 series
2008 Mondeo 2.0 TDCi Titanium X

"Always look on the bright side of life, dedo, dedo dedodedo"
saltyseadog
Newbie
Posts: 3
Joined: Sun Sep 12, 2010 4:54 pm

Re: Exhaust Rattle

Post by saltyseadog »

Thanks for the welcome teamster. No blow from the exhaust, I can't actually see any rubbers :? Sorry, I have only had the car a few weeks, so apologies for the silly questions. Is the flexible hose from the manifold to the first box?
98 406 1.9td lx 234000 Genuine Miles :)
teamster1975
Site Admin & Mad Biker!
Posts: 6277
Joined: Sun Oct 28, 2007 8:07 pm
Location: Woking, Surrey

Re: Exhaust Rattle

Post by teamster1975 »

No worries, we're here to help each other out! :)

It's not a flexible hose as such; where the pipe joins the manifold there is a clamp which pushes over the flange with a pair of bolts which have springs on them. These give up over time and cause free play (and blowing more often than not!). You can get a replacement kit from Eurocarparts for a tenner or put a load of washers behing the bolt heads to get more tension on the springs.
Right pig to get to mind you but do-able on axle stands.
1996 406 1.8LX Got a bad case of hydro lock!
1996 406 Executive 2.0 Turbo XU10J2TE No longer hangin' on in there :(
1997 Honda CB500V
2003 Volvo V40 1.8 GDi SE killed by a nutter in a beemer 5 series
2008 Mondeo 2.0 TDCi Titanium X

"Always look on the bright side of life, dedo, dedo dedodedo"
saltyseadog
Newbie
Posts: 3
Joined: Sun Sep 12, 2010 4:54 pm

Re: Exhaust Rattle

Post by saltyseadog »

Ok, I will have a look tomorrow avo. Thanks for the help mate, much appreciated :D
98 406 1.9td lx 234000 Genuine Miles :)
Post Reply