Page 1 of 1

2.0Hdi 110 Fault readings. Help Please

Posted: Fri Jun 17, 2011 5:40 am
by pbmacd
Car T-reg 2.0HDI 110

Read my faults the other day and these keep coming back.

With engine not running
Permanent fault circuit TL4226 faulty. Faulty circuit

With engine running
Permanent fault. Flowmeter signal. Open circuit or short circuit to earth

Intermittent fault. Circuit additional heating 1 open circuit or shot circuit to earth

Intermittent fault circuit tl4226 faulty. Faulty circuit


Dose anyone know if or how I should fix them.
Thanks in advance

Re: 2.0Hdi 110 Fault readings. Help Please

Posted: Fri Jun 17, 2011 6:08 am
by steve_earwig

Re: 2.0Hdi 110 Fault readings. Help Please

Posted: Mon Sep 21, 2020 8:18 am
by mpaunov69
I have the same problem. Did you found what was the problem. Car doesn't have power like before until 3000 rpm, after 3000 rpm it's accelerating well.

Re: 2.0Hdi 110 Fault readings. Help Please

Posted: Mon Sep 21, 2020 10:15 pm
by dirtydirtydiesel
I say 'Holly thread resurrection Batman ' :twisted:

Seriously though the op hasn't been on the forum for over eight year's.

Yours sounds like a duff MAFF issue.

Hence the flowmeter comment in the old post & the glowplugs always throw up flaut codes ( unless your in -10° don't worry)

Re: 2.0Hdi 110 Fault readings. Help Please

Posted: Mon Sep 21, 2020 10:47 pm
by GingerMagic
Failing MAF is likely - you can disconnect it and see if it improves ( lift the little tab on under the grey connector )