Error Code P0470 on 2.2HDi
Posted: Thu Jun 07, 2012 9:43 am
Morning,
For the last week ive had the 'Antipollution System Defective' message pops up on the screen when i start the car and the Engine Diagnostic warning Light stays on. There doesnt seem to be any loss of power and it doesnt go into super slow limp mode. Weve had a diagnostic reader on it and the two codes were P1352 and P0470. Both were cleared and the next day they returned. Some digging indicates that the P1352 may be referring to the glow plugs and probably not related (?). The P0470 is an Exhaust Pressure Sensor A Circuit according to the extensive list on the forum and an additional bit of diag software gives the following info:
Intermittent fault. Differential exhaust pressure signal. Coherence of the differential pressure when stopped.
Now, under the bonnet where the large pipe from the top of the intercooler goes to the engine there is a small bracket that has a connector plugged into it at the the end of a short pipe. This was bent down when taking a look and has since been straightened. is it possible that the connector has been disturbed or the pipe now has a leak as it looks like it may have a few cracks and that is why the message is popping up?
Thanks in advance.
Cheers
Nat
B->
For the last week ive had the 'Antipollution System Defective' message pops up on the screen when i start the car and the Engine Diagnostic warning Light stays on. There doesnt seem to be any loss of power and it doesnt go into super slow limp mode. Weve had a diagnostic reader on it and the two codes were P1352 and P0470. Both were cleared and the next day they returned. Some digging indicates that the P1352 may be referring to the glow plugs and probably not related (?). The P0470 is an Exhaust Pressure Sensor A Circuit according to the extensive list on the forum and an additional bit of diag software gives the following info:
Intermittent fault. Differential exhaust pressure signal. Coherence of the differential pressure when stopped.
Now, under the bonnet where the large pipe from the top of the intercooler goes to the engine there is a small bracket that has a connector plugged into it at the the end of a short pipe. This was bent down when taking a look and has since been straightened. is it possible that the connector has been disturbed or the pipe now has a leak as it looks like it may have a few cracks and that is why the message is popping up?
Thanks in advance.
Cheers
Nat
B->