406oc.co.uk

Need to replace diff oil seals on my 2001 HDI 90. Can anyone tell me what the dimensions of the seals are so I can order them from the motor factors? I assume they are a double lipped type? Would I be better getting them from the stealers?

I think the 'box should be this BE4-5L:
3121 44
RP 16 088 167 80
01
SEAL
40X58-10
£14.45

3121 46
01
SEAL RIGHT
29X47-11
£12.74

It doesn't mention the lips. You could probably save a few quid getting them from a factor but then you won't know about these lips, so perhaps it would be easier to get them from the dealer's. Unless you can find someone in the factors who knows what they're doing...

We replaced mine while doing the clutch/DMF job, (well, I watched while jasper5 and co., who knew what they were doing did it).

The ones from the factors didn't fit, but jasper managed to persuade the stealer's to stay open 5 minutes longer and thus avoid disaster....

They're ony a few quid IIRC, so I'd say stealer on this occasion.

Yes, dealer for sure, they aren't any cheaper from the factors and they actually fit.....I'm picking 2 up in half an hour from the dealers as it happens.

Here endeth the lesson

Now preserved for all time on the Knowledge Base ('cos I thought it was a useful little gem )

Update....

The ones I got are part number P013D02 P1608816780 £12-04p.

P024D02 P0000312165 £6-80p.

Both retail plus vat.

These are for a 110 HDi.

I was going to ask which but the parts diagram has the same numbers for ML5Cs and ML5Ts

That's for meeeee

Thanks for all the info guys. Guess I'll go to the stealers & get them.
From previous experience with 205 gearboxes I know that the genuine pug seals are a better fit, just thought I'd save some cash.