406oc.co.uk

Hi there again I am looking for sme info. My intercooler has blown and I am looking to get some info on it before I make up my mind if I should upgrade or replace.
1. I am looking for the Dimensions (in mm Height Width and Length)
2. What other cars is the Intercooler on (i.e. 2.1 HDI etc)
3. If I upgraded would it be easy to fit an after market Intercooler without all the hastle of cutting bits of the bdy off??

Thanks

2. XUD9TE (1.9TD), XUD11BTE (2.1TD), DW10ATED (HDi110)
Peugeot part 384F4, £279.44

Surprised according to servicebox the HDi134 doesn't have an i/c?!?

but according to Haynes it has both air to air and water to air

Isn't my 2.1's intercooler like a radiator, while the Hdis are a box next to the rad?

Would this fit ok

http://cgi.ebay.co.uk/PEUGEOT-406-1-9D- ... 0330741070

lynneandcrow wrote:Hi there again I am looking for sme info. My intercooler has blown and I am looking to get some info on it before I make up my mind if I should upgrade or replace.
1. I am looking for the Dimensions (in mm Height Width and Length)
2. What other cars is the Intercooler on (i.e. 2.1 HDI etc)
3. If I upgraded would it be easy to fit an after market Intercooler without all the hastle of cutting bits of the bdy off??

Thanks

1. Original intercooler dimensions are: total 780mmx320mmx30mm (widht only core 600mm)
2. I think they are same size, not 100% sure.
3. Its quite easy to modify aftermarket one to same place as original one. It took about 4 hrs total when i upgrade this http://i250.photobucket.com/albums/gg27 ... ooleri.jpg to its place. Core size is 550mmx230mmx76mm 2,5"

lynneandcrow wrote:Would this fit ok

http://cgi.ebay.co.uk/PEUGEOT-406-1-9D- ... 0330741070

doesnt look to be a1,its got some damaged fins

Thanx guys im going to get a recon one too risky thanks for all the replys

If you have a local car radiator repair place take it there ,they will test it and prob
repair it for a lot less than a replacement

mjb wrote:Surprised according to servicebox the HDi134 doesn't have an i/c?!?

steve_earwig wrote:but according to Haynes it has both air to air and water to air
Isn't my 2.1's intercooler like a radiator, while the Hdis are a box next to the rad?

The air-air is about the same as a 110, like or
The water to air is used to heat the intake air during warm-up, (& FAP regen) and is difficult to geta picture of, looks like a s/steel tube running diagonally behing the radiator like this
You can (just) see the lower air pipe connection & lower water hose.

That's quite a lot different to the 110 Doggy even the radiator connection is different and I didn't know about the water/air exchanger!

TBH I've never really looked at a 406 110, but had seen the early 307 installation & a few 406 under-bonnet pics & assumed they were the same.

I'm currently breaking a td xantia with an intercooler. I'll get a few snaps later and see if it's the one you need.