Page 1 of 1

Part identification please!

Posted: Tue Feb 24, 2009 9:48 am
by stevenlizuk
I'm trying to identify the module that sits in the box next to the ECU on my 2.1.

The car wont start and this thing is buzzing when I power up the ignition.

Is it the glowplug controller??

Cheers
Steve

Re: Part identification please!

Posted: Tue Feb 24, 2009 9:56 am
by mjb
You'll be wanting to take a picture...

If it's sitting opposite the ECU to the windscreen side of the box with a connector that has a red latch and rubber boot, it's probably a relay box and if it's buzzing will likely need replacement.

Re: Part identification please!

Posted: Tue Feb 24, 2009 10:26 am
by stevenlizuk
ECU sits to the right of the box and this module thingy sits to the left.

I am assuming it is a relay of sorts but don't know what it is called to ask for another one.

There is a picture showing it in the Heinz manual but it doesn't seem to refer to it.

Re: Part identification please!

Posted: Tue Feb 24, 2009 10:56 am
by mjb
Documentation on the various little boxes around these cars is minimal at best, and even Peugeot tend to only refer to them as "electrical box" or similar :(

Re: Part identification please!

Posted: Tue Feb 24, 2009 12:07 pm
by steve_earwig
I know the box, I had mine out a while back but, as you say, Haynes is typically enigmatic. I think it contains relays for fuel pump etc. and was one of the boxes that was buzzing when my battery died so maybe you should look at the connections.

Re: Part identification please!

Posted: Tue Feb 24, 2009 2:33 pm
by stevenlizuk
Found it.

It's a multi-function injection relay (£32=VAT).

On it's way and will be fitted tonight so fingers crossed.
I'll let you know if it works or not.

Cheers

Steve