Page 1 of 1

XUD11BTE behaving a little better

Posted: Wed Sep 09, 2009 2:20 pm
by poddack
Always had a problem with the engine running on for 5 seconds after removing the key and a engine warning light. Finally I have replaced the stop solenoid plunger and it is cured. Delphi part number 9109-719 from somewhere like Darwen Diesels or Hickleys in Taunton. The old plunger was not spring loaded and had no rubber end. The new one has both.

Re: XUD11BTE behaving a little better

Posted: Sun Sep 20, 2009 9:01 pm
by poddack
My Puglet has been starting instantly but coughing and spluttering for the first couple of hundred yards and down on power. I finally got round to swpping the glow plugs this morning, Before I swapped I measured their resistances and one was open circuit. A bit poor for glow plugs that are 9 months old. She's purring nicely again.