How easy is it to replace the dirvers mirror on my 1998 2.1TD estate?
Its a manual one.
The cowling is all smashed and the glass srazed and its MOT time next week!
Do i need to replace the whole assembly including the joystick thing inside the car?
replacing drivers mirror 1998 estate
Moderator: Moderators
- DaiRees
- Site Admin
- Posts: 5377
- Joined: Sat Aug 06, 2005 8:24 am
- Location: Merthyr Tydfil, South Wales (God's Country!)
Re: replacing drivers mirror 1998 estate
Never done one on a 406 but I've done several on various other cars in the past, most recently when the Mrs decided to smash one off against our gate pillar. They're usually piss easy to change..
I'd say change the whole thing, probably easiest option.


I'd say change the whole thing, probably easiest option.
- steve_earwig
- Moderator
- Posts: 19812
- Joined: Thu Oct 04, 2007 6:09 pm
- Location: Jastrebarsko, Croatia http://www.jastrebarsko.hr/lokacija/
Re: replacing drivers mirror 1998 estate
Go to the breakers and buy another complete with manual joystick thing. I'm sure if you can separate them but anyway it's probably much easier not to. There's 3 torx screws holding it on, if memory serves two are under little covers which you prize off with a little screwdriver. Try not to drop the screws down the inside of the door!
Unskilled meddling sin©e 2007
The submitted form was invalid. Try submitting again.
The submitted form was invalid. Try submitting again.
-
- Site Admin & Mad Biker!
- Posts: 6277
- Joined: Sun Oct 28, 2007 8:07 pm
- Location: Woking, Surrey
Re: replacing drivers mirror 1998 estate
Just as Steve said; 3 torx screws.
Wind the window down to start with.
You have to prise off the plate with the joystick rubber & pop the rubber off the end of the joystick; remove torx screw.
There's a cover just inside the door & on the door card; pop these off & remove screws; magnetic screwdriver for screw inside door card!!
Give the mirror body a wiggle; it'll be stuck on the rubber gasket but will pop off quite easily; job done!
Wind the window down to start with.
You have to prise off the plate with the joystick rubber & pop the rubber off the end of the joystick; remove torx screw.
There's a cover just inside the door & on the door card; pop these off & remove screws; magnetic screwdriver for screw inside door card!!
Give the mirror body a wiggle; it'll be stuck on the rubber gasket but will pop off quite easily; job done!
1996 406 1.8LX Got a bad case of hydro lock!
1996 406 Executive 2.0 Turbo XU10J2TE No longer hangin' on in there
1997 Honda CB500V
2003 Volvo V40 1.8 GDi SE killed by a nutter in a beemer 5 series
2008 Mondeo 2.0 TDCi Titanium X
"Always look on the bright side of life, dedo, dedo dedodedo"
1996 406 Executive 2.0 Turbo XU10J2TE No longer hangin' on in there

1997 Honda CB500V
2003 Volvo V40 1.8 GDi SE killed by a nutter in a beemer 5 series
2008 Mondeo 2.0 TDCi Titanium X
"Always look on the bright side of life, dedo, dedo dedodedo"