Page 1 of 1
electric window mechanism
Posted: Sat Dec 31, 2011 8:48 am
by kev1839
Hi Guys,
Anyone had experience in replacing the front window mechanism in the 406 ? mines the electric version ( as most are ) need to renew the actual working parts ( cables etc) see on flea bay that kits are available for 14 quid or so . easy enough to get the whole lot out the door just wondered if any one had tried to renew the parts before or had just replaced the whole thing ?? my mate tried to do it on a partner van, reckoned it was a nightmare , got a second hand unit from the scrappy in the end. What's your views guys ??
Re: electric window mechanism
Posted: Sat Dec 31, 2011 9:49 am
by omega
they are a pain
one of the bad bits is taking the mount of the bottom of the window.you need 10 inch hands to each
also theres a runner/pully wheel near the top of the door that is also hard.
good luck
Re: electric window mechanism
Posted: Sat Dec 31, 2011 11:19 am
by steve_earwig
To save Lozz the bother - don't waste your time/money on a rebuild kit, they're wank. Get one from the breaker's, watch out though 'cos there's a couple of different ones.
Re: electric window mechanism
Posted: Sat Dec 31, 2011 11:33 am
by kev1839
Thanks for that

do you know what the differences are ?? I have a 2000 D8 HDI i'm assuming pre and post 99 are different ?? or not ?
Re: electric window mechanism
Posted: Sat Dec 31, 2011 3:06 pm
by steve_earwig
kev1839 wrote: I have a 2000 D8
No you don't.
I'm sure I posted these a while back... Not really enough detail but perhaps worth looking at
viewtopic.php?f=3&t=14129&p=130953&hilit=+pinch#p130818
Re: electric window mechanism
Posted: Sat Dec 31, 2011 3:31 pm
by steve_earwig
Yep, it's the old D8/D9 thing at chassis number VF39xxxxx80800000, the driver's side is a different part number altogether (for D8s it depended if it was just electric or sequential, for D9 there can be only one), the passenger side went from a choice of anti-pinch or not on the D8 to anti-pinch only (with same part number) on the D9.
Re: electric window mechanism
Posted: Sat Dec 31, 2011 4:19 pm
by lozz
Yeah, the repair cables are awaste off space, as steve says avoid them,
basicly what they are is Bmx cables, homemade shite,the cables are either too long or too short,
grab window mech off abreaker, thats what idid after wasting money on daft cable repair kit,
Re: electric window mechanism
Posted: Sun Jan 01, 2012 11:58 am
by plod
Sounds harder than a Laguna then
Had to do both the fronts on my dads 2001 Laguna in past 12 months or so, and I managed to get the second one down to 15 mins including picking and dropping his car off
