abs fault

[charliedog]

I have recently done some work on the hub which required the removal of the hubs, renewal of one of the drives-shafts and both abs sensors. One of the drive-shafts was replaced with a new one, the other had a cv boot renewed. After putting it all back together and on road testing, the brakes juddered at low speed when coming to a stop. The dashboard light came on. The brakes still worked effectively ( other than the judder) when braking and coming to a stop. This only happens when the brake is applied at low speed!! At high and average speed the brakes work normally with no judder. Also the abs warning light does not come on every time with the judder. Any help would be appreciated.

[hammerman]

I`ll 2nd that with the juddering and abs light.The rings were broken on mine a few years ago with the same juddering.I replaced to whole cv joint as i got them for around £20 each.Easy to change once out of the hub.

[benczuk]

My reluctor ring was cracked allowing it to slide about and thus producing signal loss. I just removed it, cleaned the surface and epoxied it back in place.

4 years on it is still working fine and it saves all the faff of removing bits and heating things.

[charliedog]

My reluctor ring was cracked allowing it to slide about and thus producing signal loss. I just removed it, cleaned the surface and epoxied it back in place.

4 years on it is still working fine and it saves all the faff of removing bits and heating things.

What epoxy resin did you use for the job please?

[benczuk]

Just standard Araldite.