406oc.co.uk

hello all,
when replacing front discs and pads on an R reg 406 do i have to push the caliper pistons in with a tool as i can`t move them by hand,

I've always found a g type clamp to be good for pushing the pistons back in.

i use a screwdriver on mine

It's deja vu all over again viewtopic.php?f=27&t=16123&hilit=arse

steve_earwig wrote:It's deja vu all over again viewtopic.php?f=27&t=16123&hilit=arse

Is this another case of should have used the search feature?

Probably. But then who'd have thought one thread titled "front pads" and one titled "caliper piston" would be about the same thing?.

well i done it both sides on,

i made a pusher (same as a puller but it pushes) big bolt nut and a light bracket, sorted,

steve_earwig wrote:Probably. But then who'd have thought one thread titled "front pads" and one titled "caliper piston" would be about the same thing?.

you wana explane?

roverv8 wrote:

steve_earwig wrote:Probably. But then who'd have thought one thread titled "front pads" and one titled "caliper piston" would be about the same thing?.

you wana explane?

Tongue in cheek mate. We had a post about exactly the same thing last week entitled "caliper piston"

teamster1975 wrote:

roverv8 wrote:

steve_earwig wrote:Probably. But then who'd have thought one thread titled "front pads" and one titled "caliper piston" would be about the same thing?.

you wana explane?

Tongue in cheek mate. We had a post about exactly the same thing last week entitled "caliper piston"

lol,i had to keep reading it in case i got it wrong,