Hi All have air bag light fault on my 2002 406 estate took all conecters out of the seats and joined the wires to no avail how do i get the center of the steering wheel as in the cover so i can check under there and any one got any other ideas
also have abs brake fault light on would low brake pads cause this as front ones look low
Air Bag Light PUG 406
Moderator: Moderators
-
- 2.0 HDI 110
- Posts: 9656
- Joined: Tue Jun 01, 2010 5:42 pm
- Location: The Countryside, Northern Ireland
- Contact:
Re: Air Bag Light PUG 406
how did you join the underseat wires?, and to get the airbag pad in the wheel out stick a screwdriver in the small hole on the bottom of the wheel to release a metal clip holding it in but the underseat wires was the issue in my car as i wired them up wrongly, also do all with the battery out you dont want to get hit by an airbag.
-
- 1.6 8v
- Posts: 10
- Joined: Mon Oct 25, 2010 3:14 pm
Re: Air Bag Light PUG 406
hi made sure wires are all connected correctly with solder and taped been serching around and hear the coms 2000 could be the cause as my indicater stalk ls very loose and sometimes indicates right after a left turn do you know if this could be where the fault is and how easy is it to change as one on ebay at mo
-
- 2.0 HDI 110
- Posts: 9656
- Joined: Tue Jun 01, 2010 5:42 pm
- Location: The Countryside, Northern Ireland
- Contact:
Re: Air Bag Light PUG 406
there is a guide on how to change them, but i just brought mine to a mechanic and had it fitted for £25, it can cause the airbag light, but you can also get a fault code read into the car to see what the problem is, sometimes it can be turned off there and then if its not permanent, if it is permanent (the fault) then the codes might help to find out what to do.
- steve_earwig
- Moderator
- Posts: 19812
- Joined: Thu Oct 04, 2007 6:09 pm
- Location: Jastrebarsko, Croatia http://www.jastrebarsko.hr/lokacija/
Re: Air Bag Light PUG 406
The ecu went on my D8, everyone reckoned it'd be the clock spring behind the steering wheel but I took it in to Pug (as you would before the 406oc came into existence), they tried a new ecu and everything was fine.
Unskilled meddling sin©e 2007
The submitted form was invalid. Try submitting again.
The submitted form was invalid. Try submitting again.