Remote locking stopped working

[L12PUG]

Well.....here I go again with another problem......

Yesterday the remote locking stopped working on our 406 mk2. Initially I thought it could be down to the keyfob having no buttons for a while.....

I got a new key this morning and swapped the internals so I had one with the buttons and went to try and re sync the key. I searched and found that I needed to press and hold the large button for 20s then press the small one, the light stayed on. Then went into the car and pressed large button one, switched on ignition for 10 s then off. Bloody remote locking still don't work.

All help & advice greatly received as both manual locks just spin so I can't lock the bloody car

Anyone know what might be wrong? I put it on PP2000 and it said there was a learning problem!!

[Doggy]

Sounds like you need to use PP2000 to get it to re-'learn' the key codes.

It's in configuration somewhere, & you need the 4-character PIN code off the card you should have got with the car...

[L12PUG]

mmm...Well I do have PP2000 but not a card with a PIN code....

Any ideas how I can find out what it is?

[Doggy]

Sign up to Digital Kaos

search for 'vin to pin for peugeot and citroen'

post your VIN & someone will reply with your PIN, usually within 24 hours

(or you can give Peugeot £25 instead).

[L12PUG]

thanks doglife, i have done as you suggest............rather not give Peugeot 25 of my pounds......i'll need those to keep my 406 going

[Doggy]

That's how we roll.

(courtesy of 406 handbrakes).

[L12PUG]

Hopefully I can get to the next meet and put some names to faces