long shot 1.6 hdi 207/307 110bhp pinouts
Moderator: Moderators
-
- 1.8 8v
- Posts: 27
- Joined: Sat Apr 02, 2011 10:47 am
long shot 1.6 hdi 207/307 110bhp pinouts
i know its a 406 forium but as i fixed my last 406 treated myself to a 207 110 hdi which used to drive a treat until the battery was lose inside the cover(i had no idea) and its touched to earth on the ecu,no fuses blown and i assumed its possible ecu/bsi at fault?
pugged snap on pug planet 2000 in and came up with 2 faults aircon ,and injector curcit open short to ground,p1623(ill double check the code) now the vechical will only crank over and not start,dose anyone have a pinout for this ecu to try check things out.or what pin to check if possible
pics off inside ecu front/rear
pugged snap on pug planet 2000 in and came up with 2 faults aircon ,and injector curcit open short to ground,p1623(ill double check the code) now the vechical will only crank over and not start,dose anyone have a pinout for this ecu to try check things out.or what pin to check if possible
pics off inside ecu front/rear
- steve_earwig
- Moderator
- Posts: 19799
- Joined: Thu Oct 04, 2007 6:09 pm
- Location: Jastrebarsko, Croatia http://www.jastrebarsko.hr/lokacija/
Re: long shot 1.6 hdi 207/307 110bhp pinouts
Service Box seems to skip that fault code but from BBA - "P1623 Immobiliser code word / ID number Write failure "
I'm looking at could be the wiring diagram for your ecu (there's loads to choose from without specific details) but I'm not sure what you would be wanting to test - the injectors all have separate outputs, if there was a common fault with them it would be inside the ecu
I'm looking at could be the wiring diagram for your ecu (there's loads to choose from without specific details) but I'm not sure what you would be wanting to test - the injectors all have separate outputs, if there was a common fault with them it would be inside the ecu
Unskilled meddling sin©e 2007
The submitted form was invalid. Try submitting again.
The submitted form was invalid. Try submitting again.
-
- 1.8 8v
- Posts: 27
- Joined: Sat Apr 02, 2011 10:47 am
Re: long shot 1.6 hdi 207/307 110bhp pinouts
first just have to say i dint expect a reply tbh secondly many thanks for the input/advise ,as tbh i know buggar all regards this type of ecu/bsi other then there a bloody nightmare, i have found a very very small part which has been melted of the board , which brings me to think its more of what you say a ecu fault,
question is ive found a few ecus but theres a few numbers differnert , but complete set up would be avaible ? ie ecu,bsi,key chip,transponder ?
but some say i need the clocks as well other say not ,which im not totaly tbh, i can only think of 3 options replace all the set up and see if it runs, send ecu off for a possible repair or try locate one with identical numbers(hard work) oh or fire the twat lol
question is ive found a few ecus but theres a few numbers differnert , but complete set up would be avaible ? ie ecu,bsi,key chip,transponder ?
but some say i need the clocks as well other say not ,which im not totaly tbh, i can only think of 3 options replace all the set up and see if it runs, send ecu off for a possible repair or try locate one with identical numbers(hard work) oh or fire the twat lol
Re: long shot 1.6 hdi 207/307 110bhp pinouts
In a 207 the mileage will be stored in the dash and BSI, so you'll need a ECU, BSI, Transponder and Dashboard. If you are going that route.
OR make sure the 2nd hand BSI has LESS mileage than what yours has
If you get a ECU, it needs to be exactly the same
If the ECU is dead, but the IMMO still works, then you can get a 2nd ECU [just the ECU] and I'll try and get you sorted with a guy who will copy the IMMO code off your old ECU and put it into the new one.
OR make sure the 2nd hand BSI has LESS mileage than what yours has
If you get a ECU, it needs to be exactly the same
If the ECU is dead, but the IMMO still works, then you can get a 2nd ECU [just the ECU] and I'll try and get you sorted with a guy who will copy the IMMO code off your old ECU and put it into the new one.
- steve_earwig
- Moderator
- Posts: 19799
- Joined: Thu Oct 04, 2007 6:09 pm
- Location: Jastrebarsko, Croatia http://www.jastrebarsko.hr/lokacija/
Re: long shot 1.6 hdi 207/307 110bhp pinouts
I actually find this sort of thing interestingadaptorman wrote:first just have to say i dint expect a reply tbh
Unskilled meddling sin©e 2007
The submitted form was invalid. Try submitting again.
The submitted form was invalid. Try submitting again.
-
- 1.8 8v
- Posts: 27
- Joined: Sat Apr 02, 2011 10:47 am
Re: long shot 1.6 hdi 207/307 110bhp pinouts
i do if i can get my head around , i think pugs are harder then most vechicals to understandsteve_earwig wrote:I actually find this sort of thing interestingadaptorman wrote:first just have to say i dint expect a reply tbh
just found this missing off ecu, maybe why it wount run ?
-
- 1.8 8v
- Posts: 27
- Joined: Sat Apr 02, 2011 10:47 am
Re: long shot 1.6 hdi 207/307 110bhp pinouts
ps anyone which chip the immo is?
-
- 1.8 8v
- Posts: 27
- Joined: Sat Apr 02, 2011 10:47 am
Re: long shot 1.6 hdi 207/307 110bhp pinouts
close only one near matching this is 951603?leehdi wrote:95160
bloody hell theres some right hdi nutters on here pmsl , nice one pal ,(next thing how the hell do you see the numbers theres so tiny lol
Re: long shot 1.6 hdi 207/307 110bhp pinouts
Sorry, looked at the wrong ECU like a plank
Its 95640 on the edc16c34
Its 95640 on the edc16c34
-
- 1.8 8v
- Posts: 27
- Joined: Sat Apr 02, 2011 10:47 am
Re: long shot 1.6 hdi 207/307 110bhp pinouts
bloody hell ,lee i carnt find any chip with this number???leehdi wrote:Sorry, looked at the wrong ECU like a plank
Its 95640 on the edc16c34
Re: long shot 1.6 hdi 207/307 110bhp pinouts
What year is the car?
CAN-CAN or CAN-VAN?
Either should be 95160 or 95640, and flash file should be 2kb
CAN-CAN or CAN-VAN?
Either should be 95160 or 95640, and flash file should be 2kb
-
- 1.8 8v
- Posts: 27
- Joined: Sat Apr 02, 2011 10:47 am
Re: long shot 1.6 hdi 207/307 110bhp pinouts
hi lee , i personaly dont know which it is other then the ecu numbers/info above and ats 56plate 207,leehdi wrote:What year is the car?
CAN-CAN or CAN-VAN?
Either should be 95160 or 95640, and flash file should be 2kb
-
- 1.8 8v
- Posts: 27
- Joined: Sat Apr 02, 2011 10:47 am
Re: long shot 1.6 hdi 207/307 110bhp pinouts
only one emmprom as anything close which is 951603/understeath it says 9630w, you lost me on the flash file , unless you have it you can possble send , as im still pin checking as yet ..nightmare lol