error code help needed please
Moderator: Moderators
error code help needed please
over the last few days, i have been getting a few error codes on my engine management indicator light. i have read the errors and the crossed referenced them with the manual:
P0220 - TPS/Pedal Position Sensor/Switch B Circuit Malfunction
P0221 - TPS/Pedal Position Sensor/Switch B CKT Range Performance
P0225 - TPS/Pedal Position Sensor/Switch C Circuit Malfunction
now i would like to know please, are these all related? can they all be solved by replacing the same part? and if so/not, which part/s do i need to replace?
my car is a 2.2 sri d9.
thanks in advance.
P0220 - TPS/Pedal Position Sensor/Switch B Circuit Malfunction
P0221 - TPS/Pedal Position Sensor/Switch B CKT Range Performance
P0225 - TPS/Pedal Position Sensor/Switch C Circuit Malfunction
now i would like to know please, are these all related? can they all be solved by replacing the same part? and if so/not, which part/s do i need to replace?
my car is a 2.2 sri d9.
thanks in advance.
Past car - D9 2.2 SRi estate, sleeper, family wagon & general hauler!
Current car - Ph3 1.8 306
Current car - Ph3 1.8 306
- steve_earwig
- Moderator
- Posts: 19813
- Joined: Thu Oct 04, 2007 6:09 pm
- Location: Jastrebarsko, Croatia http://www.jastrebarsko.hr/lokacija/
Re: error code help needed please
They seem to be related 'cos they're all the throttle position sensor
Could this be the problem? I'd head off to check the connector on it. Don't just replace it without verifying - they aint cheap 


Unskilled meddling sin©e 2007
The submitted form was invalid. Try submitting again.
The submitted form was invalid. Try submitting again.
Re: error code help needed please
well i had a look on sunday - i unplugged what i thought was the TPS (the half circle thing that the throttle cable attaches to on the passenger side of the engine bay - can you confirm this please?) checked it was clean then gave it a squirt of wd40 and reconnected.
Past car - D9 2.2 SRi estate, sleeper, family wagon & general hauler!
Current car - Ph3 1.8 306
Current car - Ph3 1.8 306
- Welly
- The moderator formally known as Welton
- Posts: 15033
- Joined: Tue Jan 10, 2006 12:52 pm
- Location: East Midlandfordshire
Re: error code help needed please
That's a good place to start (cleaning/checking the connector) then if the fault continues you can look at replacing the sensor (my one for an HDi was about £70.00 in 2006).
Something worth remembering is that the fault may also lie in the wiring/earthing to/from the sensor rather than the sensor itself. There may be some corrosion at the ECU's multi plug or some damaged wiring in the loom somewhere. When the HDi's first came out there were numerous faults with the TPS's and the dealers took to running separate earths from the (previously shared) MAF and TPS units and this cured the problem.
Sensors with variable outputs like the TPS can be checked for condition on an Oscilloscope doo-dad.
Something worth remembering is that the fault may also lie in the wiring/earthing to/from the sensor rather than the sensor itself. There may be some corrosion at the ECU's multi plug or some damaged wiring in the loom somewhere. When the HDi's first came out there were numerous faults with the TPS's and the dealers took to running separate earths from the (previously shared) MAF and TPS units and this cured the problem.
Sensors with variable outputs like the TPS can be checked for condition on an Oscilloscope doo-dad.
Cars in my care:
2021 Kia Spottage 1.6 Pez Turbo Dual Clutch Gearbox Trickery
2013 Renner Twingo - donkey work
2021 Kia Spottage 1.6 Pez Turbo Dual Clutch Gearbox Trickery
2013 Renner Twingo - donkey work
Re: error code help needed please
mine is a petrol, so might it have the same probs as the hdi's?
is that deffo the right sensor i stated?
is that deffo the right sensor i stated?
Past car - D9 2.2 SRi estate, sleeper, family wagon & general hauler!
Current car - Ph3 1.8 306
Current car - Ph3 1.8 306
Re: error code help needed please
just been out to look at the car - there are 4 wires going into the plug - would it be worth connecting one of them to a seperate earth? if so, which wire?
Past car - D9 2.2 SRi estate, sleeper, family wagon & general hauler!
Current car - Ph3 1.8 306
Current car - Ph3 1.8 306
- steve_earwig
- Moderator
- Posts: 19813
- Joined: Thu Oct 04, 2007 6:09 pm
- Location: Jastrebarsko, Croatia http://www.jastrebarsko.hr/lokacija/
Re: error code help needed please
Seems to apply to HDis - your car has no MAF
Incidentally, the TPS is quite a common part, the one on the HDi is the same.

Incidentally, the TPS is quite a common part, the one on the HDi is the same.
Unskilled meddling sin©e 2007
The submitted form was invalid. Try submitting again.
The submitted form was invalid. Try submitting again.
Re: error code help needed please
i heard this before, so i'm trawling the web. thanks.steve_earwig wrote:
Incidentally, the TPS is quite a common part, the one on the HDi is the same.
Past car - D9 2.2 SRi estate, sleeper, family wagon & general hauler!
Current car - Ph3 1.8 306
Current car - Ph3 1.8 306
- steve_earwig
- Moderator
- Posts: 19813
- Joined: Thu Oct 04, 2007 6:09 pm
- Location: Jastrebarsko, Croatia http://www.jastrebarsko.hr/lokacija/
Re: error code help needed please
I just stuffed a list of them on the coupé club. Go for the engines 'cos it'll probably apply to other models, plus Citroens and Fiats.
Unskilled meddling sin©e 2007
The submitted form was invalid. Try submitting again.
The submitted form was invalid. Try submitting again.
Re: error code help needed please
thanks 'mr wardrobe'. lol
Past car - D9 2.2 SRi estate, sleeper, family wagon & general hauler!
Current car - Ph3 1.8 306
Current car - Ph3 1.8 306
- steve_earwig
- Moderator
- Posts: 19813
- Joined: Thu Oct 04, 2007 6:09 pm
- Location: Jastrebarsko, Croatia http://www.jastrebarsko.hr/lokacija/
Re: error code help needed please
Shhh, that's my "under cover" username 

Unskilled meddling sin©e 2007
The submitted form was invalid. Try submitting again.
The submitted form was invalid. Try submitting again.
Re: error code help needed please
sounds intriging?steve_earwig wrote:Shhh, that's my "under cover" username
Past car - D9 2.2 SRi estate, sleeper, family wagon & general hauler!
Current car - Ph3 1.8 306
Current car - Ph3 1.8 306
-
- 2.0 HDI 110
- Posts: 9656
- Joined: Tue Jun 01, 2010 5:42 pm
- Location: The Countryside, Northern Ireland
- Contact:
Re: error code help needed please
whats the sensor mounted to the right hand side of the radiator/intercooler which says denso, in the engine bay of a 110 hdi?
- steve_earwig
- Moderator
- Posts: 19813
- Joined: Thu Oct 04, 2007 6:09 pm
- Location: Jastrebarsko, Croatia http://www.jastrebarsko.hr/lokacija/
Re: error code help needed please
No, it's not. I didn't expect to be posting on their so I used my incognito username. Don't tell me everyone else has 1 username for every single forum they go on
-JJ

-JJ
Unskilled meddling sin©e 2007
The submitted form was invalid. Try submitting again.
The submitted form was invalid. Try submitting again.
- Welly
- The moderator formally known as Welton
- Posts: 15033
- Joined: Tue Jan 10, 2006 12:52 pm
- Location: East Midlandfordshire
Re: error code help needed please
That's the boost pressure sensor.406executiveHDI wrote:whats the sensor mounted to the right hand side of the radiator/intercooler which says denso, in the engine bay of a 110 hdi?
Cars in my care:
2021 Kia Spottage 1.6 Pez Turbo Dual Clutch Gearbox Trickery
2013 Renner Twingo - donkey work
2021 Kia Spottage 1.6 Pez Turbo Dual Clutch Gearbox Trickery
2013 Renner Twingo - donkey work