A vibration which isn't vibrating?

Discuss, ask, or get help with engine and mechanical queries in here.

Moderator: Moderators

Post Reply
Scaramanga
Newbie
Posts: 8
Joined: Sat Jan 01, 2011 4:39 pm

A vibration which isn't vibrating?

Post by Scaramanga »

Folks

I've read through various entries on the site about various vibrations on a 406 HDI 110. Now, as I'm about as mechanical as plank of wood, I am none the wiser though do see many references to DMFs (and yes, i actually do know what that means :D ). Anyway, I got my 2001 110HDI Exec estate in December after it was left to my by deceased father-in-law. Apart from a dud battery, an intermittant ABS failure warning and a still non-working audio unit, it is a lovely car on 105k. Anyway, over the last 6-8 weeks, it has developed a vibration noise. The noise itself is like a rumbling/whine. It is intermittant and is noticeable through acceleration until around 1800-2000rpm where it seems to drop off. When i change into a higher gear and drop back into this rev range, the noise returns. If I am stationary and go through the rev range, again up to 1800rpm, the noise is evident.

As I said, the noise is intermittant. There have been times where I have been running the car for say 20miles, stopped and turned ignition off and there's been no vibration during the journey. If I immed restart the engine, the vibration sometimes just appears. Like I say in the topic header, the noise is a vibration I can hear but I cannot feel a physical vibration through the pedals, wheel or body of car.

It's going for MOT on Saturday and I'm going to ask the garage to take a look at the vibration but was wondering whether the 406oc had any thoughts?

I need to get it sorted asap as we sold my wifes' Astra to accomodate the 406 and she's now refusing to drive it (she's thrown me the keys and has taken over my 2009 Mazda6- not a fair trade!)

Scaramanga
User avatar
Captain Jack
3.0 24v
Posts: 3820
Joined: Sun Aug 07, 2005 11:26 am
Location: Langford, Somerset

Re: A vibration which isn't vibrating?

Post by Captain Jack »

Prime suspects are engine mounts and a crank pulley.
2003 - 2008: 1998 Peugeot 406 2.1 TD 110bhp LX Saloon
2008 - 2009: 2004 Honda Accord 2.2 CDTI 136bhp Executive Saloon
2009 - 2013: 2002 Peugeot 406 2.0 HDI 110bhp Executive Saloon
2013 - 2021: 2007 Peugeot 407 2.2 HDI 170bhp Executive Saloon (mapped to 213bhp :twisted:)
2021 - ????: 2016 Ford Mondeo 2.0 TDCi 180bhp Titanium
User avatar
steve_earwig
Moderator
Posts: 19813
Joined: Thu Oct 04, 2007 6:09 pm
Location: Jastrebarsko, Croatia http://www.jastrebarsko.hr/lokacija/

Re: A vibration which isn't vibrating?

Post by steve_earwig »

Crank pulley is the most worrying. I was thinking also loose heat shield or disintegrating silencer.
Unskilled meddling sin©e 2007

The submitted form was invalid. Try submitting again.
Scaramanga
Newbie
Posts: 8
Joined: Sat Jan 01, 2011 4:39 pm

Re: A vibration which isn't vibrating?

Post by Scaramanga »

Steve/Captain Jack

Thanks for the replies. I will ask my garage to check these when the car is with them on Sat. I assume that the crank problem would be a very expensive repair?
User avatar
Captain Jack
3.0 24v
Posts: 3820
Joined: Sun Aug 07, 2005 11:26 am
Location: Langford, Somerset

Re: A vibration which isn't vibrating?

Post by Captain Jack »

It's not as scary as it sounds and not overly expensive as it's easy enough to change. Aux belt off, undo the bolt holding the pulley, replace with a new pulley, tighten the bolt and refit the aux belt.

The biggest issue people seem to face is undoing the bolt as it can be quite tight, but it's a simple job.

I think around 130 squids all in for this kind of job.
2003 - 2008: 1998 Peugeot 406 2.1 TD 110bhp LX Saloon
2008 - 2009: 2004 Honda Accord 2.2 CDTI 136bhp Executive Saloon
2009 - 2013: 2002 Peugeot 406 2.0 HDI 110bhp Executive Saloon
2013 - 2021: 2007 Peugeot 407 2.2 HDI 170bhp Executive Saloon (mapped to 213bhp :twisted:)
2021 - ????: 2016 Ford Mondeo 2.0 TDCi 180bhp Titanium
Post Reply