Engine stalls after 2-3 minutes of starting...

Discuss, ask, or get help with engine and mechanical queries in here.

Moderator: Moderators

Post Reply
DH1972
1.8 8v
Posts: 30
Joined: Fri Apr 20, 2007 7:34 pm

Engine stalls after 2-3 minutes of starting...

Post by DH1972 »

Hi

In the past week or two my '98 V6 Estate has started being a pain in the arse - I thought that it was just down to the sub-zero morning frosts but it's doing it now whenever the engine is cold.

I start it up no bother and let it idle for a few minutes then it just dies on me and takes a fair while to start again and I can get on the move. It's a pain as I now wait for it to do this rather than go off and stall on the road.

Therer is a gauge, which I think may be fuel pressure, between the rev and mph dials, which goes up to max on first start, then drops back when the engine is running. On the start attempts subsequent to the stall this gauge doesn't move, but I think that it used to.

Any advice?

(Merry Xmas btw)
V6Exec
3.0 24v
Posts: 535
Joined: Mon Apr 23, 2007 11:17 pm
Location: Herts

Re: Engine stalls after 2-3 minutes of starting...

Post by V6Exec »

Sometimes get an odd one in mine, if she goes not catch the start first time it can be another 2-3 minutes before she will start. I assume it is a fuelling issue.

A 98' would be a D8 and I think the dial you mentioned is the electronic dipstick.

Could be that the problem is cold related and is one of the many temp sensors giving a mis-read leading to fuel miscalculation.

Good luck getting things sorted. :cheesy:
Remember - it only takes a few inches of water to drown a 406 don't make the same mistake I made! The V6 Exec is no more.

406 Coupe S HDi

PP2000 clone interface
Post Reply