whats my clarion cd player worth

[no2lurch]

its fully working, and is compatible with a multichanger (not included).

whats it worth?

[Bailes1992]

Do D9's have a standard ISO connection as standard like the D8's?

[mjb]

Do D9's have a standard ISO connection as standard like the D8's?

No. The D9 has 3 VAN bus pins wired to the BSI. Also, cars with the JBL amplifier carry line-level signals to the amp over the speaker lines

[no2lurch]

Which adaptor do I need to convert my d9 w reg Sri estate to iso plug?

[DiscoPol]

I didnt need any adapter to convert my W reg 2000 GTX HDi, just a bit of jiggery pokery on the power side as pug have the switched (Ign)feed and permanent feed arse about face, swapped red for yellow as i remember and its all good, just plug and play

[DiscoPol]

No. The D9 has 3 VAN bus pins wired to the BSI. Also, cars with the JBL amplifier carry line-level signals to the amp over the speaker lines

I think MJB is referring to the additional plug that is at top in the back of the Clarion head units with a few poxy little wires coming out of it, that is not standard iso,

but,


and i can only go from empirical research on this and claim to know nothing more than the fact i swapped mine out a month ago so can tell you that the lower two plugs are standard ISO plugs and go straight in to new stereos as i said probably have to swap over your power feeds but mine wasnt any trouble at all.

[mjb]

No. The D9 has 3 VAN bus pins wired to the BSI. Also, cars with the JBL amplifier carry line-level signals to the amp over the speaker lines

I think MJB is referring to the additional plug that is at top in the back of the Clarion head units with a few poxy little wires coming out of it, that is not standard iso, .

No, the D9 has VAN bus lines on the power connector where the lines for illumination, speed and something else should be. As also pointed out above, the perm and switched +12v lines are also swapped.

[DiscoPol]

No, the D9 has VAN bus lines on the power connector where the lines for illumination, speed and something else should be. As also pointed out above, the perm and switched +12v lines are also swapped.

so its just plug and play as far the connectors go then?
all i had to do was swap the powers over and its all still working fine to date