Outside Temp Sensor

highlander · Post by **highlander** » Mon Dec 27, 2010 12:17 am

The whole ROM chip on the MFD unit would need to be completely replaced with a new unit containing the replacement graphic (i.e. this would be a tremendous pain in the ass to do, and would require a compatible EPROM unit, EPROM-flashing hardware and software, and the computerist would need to have the necessary skills to copy in a complete ROM unit, locate and interpret the graphic file, and change it to the Pug logo. Also, the computerist would need to be skilled enough to remove the original ROM from the MFD and replace it with the EPROM.

Really, don't go there

FarmerPug · Post by **FarmerPug** » Mon Dec 27, 2010 1:06 am

It would be a nice touch though

Archangel · Post by **Archangel** » Mon Jan 03, 2011 4:51 pm

ROM is not usually changeable , its a fixed constant thing ( like burned in ? ??? ) rom module if there was one might be changed for one that has it done but otherwise NO!!

highlander · Post by **highlander** » Mon Jan 03, 2011 4:58 pm

If you had the right tools and the right know-how, you could potentially copy the content of the ROM chip, modify the image, and burn it on to an EPROM.

It's just not worth doing, given that if you do it wrong, you WILL screw your car's MFD unit (or possibly even the BSI).

FarmerPug · Post by **FarmerPug** » Mon Jan 03, 2011 10:55 pm

it would be good if you could do it.

406oc.co.uk

Outside Temp Sensor

Re: Outside Temp Sensor

Re: Outside Temp Sensor

Re: Outside Temp Sensor

Re: Outside Temp Sensor

Re: Outside Temp Sensor