Got the wiper arms off now paint.

Talk about whats Hot or Not in your 406. Fitting Leather? New Steering Wheel? Changed the pedals? Ask and tell in here!

Moderator: Moderators

Post Reply
FarmerPug
2.0 HDI 110
Posts: 9656
Joined: Tue Jun 01, 2010 5:42 pm
Location: The Countryside, Northern Ireland
Contact:

Got the wiper arms off now paint.

Post by FarmerPug »

I got one of them wiper arm removal tools:
http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... 211wt_1141

and at last ive now been able to get the windscreen wiper arms off, with this tool you need to loosen the bolts holding the wiper down, but dont take it off, because it holds the bit that pushes in place without it slipping off under pressure. Then you just turn the handle (not the best handle for getting a good grip on) and you near a nice clunk noise when its off.
For the drivers wiper you need to turn it on, and make it stop at the top for the tool to fit in, then do the same, with the bonnet in the way its a bit trickier gripping the handle but it comes off. There was no rust they were just on there good and tight.

So here are the wipers at the moment, this is why i want to paint them:
Image
Image
Image
Image
Image
Image
Image
Image
Image
Theres a bit of rust there, but it should sand out ok, i just need a bit of advice on what to paint them with, ive some grey primer i plan to sand the arms down first then put the primer on and some matte black, should i be using anything else such as a different primer or something about the rust.
And see in around the hinged part where there is missing paint, is there a way to take out the pin to spay in behind that properly?
I also have similar spits of rust on the black post that holds the rear 1/4 windows in place, can they be done in the same way.
leehdi
2.0 16v
Posts: 117
Joined: Wed Oct 15, 2008 10:45 pm
Location: Sheffield
Contact:

Re: Got the wiper arms off now paint.

Post by leehdi »

Tap the top of the wiper with a hammer, it loosens the rust on the splines and you could have taken it off
FarmerPug
2.0 HDI 110
Posts: 9656
Joined: Tue Jun 01, 2010 5:42 pm
Location: The Countryside, Northern Ireland
Contact:

Re: Got the wiper arms off now paint.

Post by FarmerPug »

that technique was tried my wipers wouldnt come off. they were on rightly.
FarmerPug
2.0 HDI 110
Posts: 9656
Joined: Tue Jun 01, 2010 5:42 pm
Location: The Countryside, Northern Ireland
Contact:

Re: Got the wiper arms off now paint.

Post by FarmerPug »

heres a picture of the back door bars
Image
Image
these are just plain metal arent they, i think i can remember how they come out might give it a go, and then paint these, is there any special paint here or are these just matte.
FarmerPug
2.0 HDI 110
Posts: 9656
Joined: Tue Jun 01, 2010 5:42 pm
Location: The Countryside, Northern Ireland
Contact:

Re: Got the wiper arms off now paint.

Post by FarmerPug »

does anyone know how to remove that pin in the wiper arm so i can paint in behind the hinged part?
FarmerPug
2.0 HDI 110
Posts: 9656
Joined: Tue Jun 01, 2010 5:42 pm
Location: The Countryside, Northern Ireland
Contact:

Re: Got the wiper arms off now paint.

Post by FarmerPug »

i painted the arms, used that hycote grey primer and matte black. Preperation could have been done a bit better, up close i can see bits of old paint, and this new paint doesnt seem to be very strong, but if your not looking at it up close ie just standing at the side of the car you cant tell, from inside the worn away look is gone:
Image
Image
Post Reply