airbag light

Discuss, ask, or get help with engine and mechanical queries in here.

Moderator: Moderators

Post Reply
User avatar
mjb
Site Admin
Posts: 7983
Joined: Wed May 31, 2006 9:06 pm
Location: Stoke

Post by mjb »

Wiggling the wires under the drivers seat seems to be a common fix for this one I think?
User avatar
jameslxdt
3.0 24v
Posts: 2512
Joined: Wed Apr 26, 2006 9:30 pm
Location: London, on me bike
Contact:

Post by jameslxdt »

the airbag light is not part of the mot, only the abs light is
Peugeot wrote:what are you worried about? we made car that lasted 10 years"..."Zat is very goode non? :|
FAQ - 406 D8 petrol (excl. V6) running and starting problems
User avatar
pug406gtx
2.0 16v
Posts: 135
Joined: Tue Aug 09, 2005 5:40 pm
Location: Coatbridge
Contact:

Post by pug406gtx »

Abag light wont fail mot i changed my steering wheel in the pug so airbag light went mental until i decided to take the damn bulb out :cheesy:
User avatar
wes1001
2.0 16v
Posts: 177
Joined: Tue Dec 19, 2006 9:10 am
Location: Sticky out bit, right on the tip of Kent, practically in the channel !!

Post by wes1001 »

Stake my life on it being the orange seatbelt tensioner connector under the seats at the front. Raise the seat up as far as it will go and slide them all the way back for easier access. Either unclick them from their holders and tape them to something else to keep tension on the connector block or cut the connectors off and hard solder the wires together.

BTW none of these mods will set the airbags off. Make sure you check both as on mine it was the passenger side. :cheesy:
Image
User avatar
DaiRees
Site Admin
Posts: 5377
Joined: Sat Aug 06, 2005 8:24 am
Location: Merthyr Tydfil, South Wales (God's Country!)

Post by DaiRees »

Yup, mine was the passenger side too.
Image
Playtime_Fontayne wrote:"Dai Rees Supplier of Fine Automobilia. Established 2007"
pipe*n*slippers
1.8 8v
Posts: 24
Joined: Fri Oct 27, 2006 6:43 pm
Location: lincolnshire
Contact:

Post by pipe*n*slippers »

Had same problem with mine.Was told it was dirty contacts under the seats and they would need to come out to be cleaned.I just Slid both seats as far forwards as they would go then as far back as they would go then put them in back normal positions and hey presto light hasnt come on since.Give it a try wot you got to loose :cheesy:
Bloody hell cars aint that bad
Post Reply