Roof Console

[zubby]

hey guys . looking for a sunroof console housing complete... will also pay shipping...

[dirtydirtydiesel]

If no one on here helps, try posting on the 406 farcebook page

[zubby]

Been there done that... may have to use a tire iron next. not even fish bros could find it

[zubby]

BTW getting a fault code p0341 and p0410 ..camshaft position sensor 'A" circuit range and secondary air injection system..how do I fix these? Please and Thanks.

[GingerMagic]

Hi Zubby.
Just to say that only sunroof equipped cars have that centre light set up ( I don't mean the switch part, the whole thing is smaller... ) so limited parts available I should imagine.
I'll check my shed as my old donor car had a sunroof - I may still have that in a box.
As for the fault codes, clear them and see what comes back - the cam sensor is needed to start the engine (it talks with the crank sensor to make sure everything is lined up and spinning fast before telling the ECU to fire the injectors )
If it fails then the car won't start, so it's with old fault or a dodgy wire under the fuel rail.....
Not sure about the other code - depends if you are diesel or petrol.

[PeterN]

I will check my scrap one, although from memory it looks different to that, its a '51 reg.

Peter

[steve_earwig]

Not sure about the other code - depends if you are diesel or petrol.

Car model/trim level:
1.8 16V 4AT (112HP)

[GingerMagic]

Not sure about the other code - depends if you are diesel or petrol.

Car model/trim level:
1.8 16V 4AT (112HP)

Doh..
Won't be the MAF then.....

[zubby]

No not the MAF.

[GingerMagic]

I've got one, just dug it out of my shed....

It does look different to yours as my buttons are not the same - this one is from a 2004 exec.

Maybe you can post a picture of the back of yours and I'll check the connections are the same.

[dirtydirtydiesel]

406 forum to the rescue agian

[zubby]

Will do that in a bit.... Post a pic of yours..