D9 electric memory seats

jameslxdt · Post by **jameslxdt** » Tue Jun 12, 2007 8:43 pm

does anyone have a wiring diagram for the D9 electric heated memory seats?

Captain Jack · Post by **Captain Jack** » Thu Jun 14, 2007 7:31 am

If you don't have the memory module thing (i.e. it's been cut off) then you'll need to hard wire the seats in. Passenger seat is quite easy as that doesn't use memory functions anyway so you can simply wire that in. I can't remember what colour wires there are but you'll need to feed a 12v (IIRC) feed into the switch and also the ground. It's easy to see which wires you need to connect as it will be the only one going to the switch that has a loose end.

Driver's seat you'll need to open up the switch and solder a wire to one of the pads (you'll see it straight away - the one in the middle). Again, I can't remember which feed that is but I believe it's a positive. If you need an idea of how they connect then open up the switch on the passenger seat, it should be identical in the end (except the missing wire is already there).

jameslxdt · Post by **jameslxdt** » Fri Jun 15, 2007 8:39 pm

many thanks
all done now, along with the heated seats

Captain Jack · Post by **Captain Jack** » Fri Jun 15, 2007 10:23 pm

I still gotta get around to the heated seats thing... are those easy to wire in?

jameslxdt · Post by **jameslxdt** » Sat Jun 16, 2007 3:10 pm

yep, wiring is all there, its the brown 2 way plugs under the seats, with the grey and yellow wires ( i think), get a pair of switches and cut the pen holder out of the centre console and fit them to the 4 way green plug and black plug, the drivers seat is the black one and passanger seat is obviously the green one