i am new to the peugeot 406 i have a p reg 2.0 non turbo
the problem i am getting is when i put the foot down the revs start bouncing about like its red lining
down low in the revs its fine but over 3 you get a loss of power and in 5th it wont go over 4k anyone got any ideas??
thank you
NEW TO 406'S NOT RUNNING RIGHT
Moderator: Moderators
- steve_earwig
- Moderator
- Posts: 19813
- Joined: Thu Oct 04, 2007 6:09 pm
- Location: Jastrebarsko, Croatia http://www.jastrebarsko.hr/lokacija/
Re: NEW TO 406'S NOT RUNNING RIGHT
hi there
the problem is i don't really understand your question is it the rev counter going mental or is it the engine if its the engine then i reckon your clutch is going if its the rev counter with a misfire then you could try reseating your engine management ecu or have a search on this here forum cos its come up on here before
my pleasure
the problem is i don't really understand your question is it the rev counter going mental or is it the engine if its the engine then i reckon your clutch is going if its the rev counter with a misfire then you could try reseating your engine management ecu or have a search on this here forum cos its come up on here before
my pleasure
Unskilled meddling sin©e 2007
The submitted form was invalid. Try submitting again.
The submitted form was invalid. Try submitting again.
- jameslxdt
- 3.0 24v
- Posts: 2512
- Joined: Wed Apr 26, 2006 9:30 pm
- Location: London, on me bike
- Contact:
Re: NEW TO 406'S NOT RUNNING RIGHT
does sound like a slipping clutch
FAQ - 406 D8 petrol (excl. V6) running and starting problemsPeugeot wrote:what are you worried about? we made car that lasted 10 years"..."Zat is very goode non?
Re: NEW TO 406'S NOT RUNNING RIGHT
sorry its hard to explain the clutch is new it pulls fine up to about 3k then you get no power and a kangaroo effect in 4th it will pick up again about 4k and pull ok to about 90 but 5th it wont go over 3k the rev bounce like its hitting the limiter. how to i reset the ect ??
-
- Site Admin & Mad Biker!
- Posts: 6277
- Joined: Sun Oct 28, 2007 8:07 pm
- Location: Woking, Surrey
Re: NEW TO 406'S NOT RUNNING RIGHT
Sounds similar to this post; TDC sensor 

1996 406 1.8LX Got a bad case of hydro lock!
1996 406 Executive 2.0 Turbo XU10J2TE No longer hangin' on in there
1997 Honda CB500V
2003 Volvo V40 1.8 GDi SE killed by a nutter in a beemer 5 series
2008 Mondeo 2.0 TDCi Titanium X
"Always look on the bright side of life, dedo, dedo dedodedo"
1996 406 Executive 2.0 Turbo XU10J2TE No longer hangin' on in there

1997 Honda CB500V
2003 Volvo V40 1.8 GDi SE killed by a nutter in a beemer 5 series
2008 Mondeo 2.0 TDCi Titanium X
"Always look on the bright side of life, dedo, dedo dedodedo"