A number of clips have broken off the front passenger side and the drivers rear. Does anyone have any tips on refitting these before I start (apart from the obvious).
Thanks
Mike
Replacing door sill rubber clips
Moderator: Moderators
-
DaiRees
- Site Admin
- Posts: 5377
- Joined: Sat Aug 06, 2005 8:24 am
- Location: Merthyr Tydfil, South Wales (God's Country!)
Re: Replacing door sill rubber clips
They're dead easy to change fella and only cost pennies form the stealer, 6p each IIRC, so get a bag full! 
Playtime_Fontayne wrote:"Dai Rees Supplier of Fine Automobilia. Established 2007"
-
bangernom1cs
- 2.0 16v
- Posts: 182
- Joined: Wed Jul 09, 2008 4:00 pm
Re: Replacing door sill rubber clips
HI,
You usually get left with half a clip in each hole.
A good grip with sum pliers usually does the trick by pulling on the old clip sharply.
Whilst the hole's open a squirt of aerosol waxoyl should help rust prevention.
(see the water sloshing in sills thread)
Tony
You usually get left with half a clip in each hole.
A good grip with sum pliers usually does the trick by pulling on the old clip sharply.
Whilst the hole's open a squirt of aerosol waxoyl should help rust prevention.
(see the water sloshing in sills thread)
Tony