Stalk blanking plate
Moderator: Moderators
Stalk blanking plate
Read mention of a little part to fill the hole when removing the stereo remote stalk. Anyone know where I could buy such a thing?
- steve_earwig
- Moderator
- Posts: 19813
- Joined: Thu Oct 04, 2007 6:09 pm
- Location: Jastrebarsko, Croatia http://www.jastrebarsko.hr/lokacija/
Re: Stalk blanking plate
Looks like it's #7 on the diagram here:

I think you'd have to get lucky in the breakers, or the dealers still seem to do them:
4131G8 MOULDING 4.31 GBP (for a tiny bit of plastic?
)
I think you'd have to get lucky in the breakers, or the dealers still seem to do them:
4131G8 MOULDING 4.31 GBP (for a tiny bit of plastic?

Unskilled meddling sin©e 2007
The submitted form was invalid. Try submitting again.
The submitted form was invalid. Try submitting again.
Re: Stalk blanking plate
I think I may have to fork out at the dealers, stupid I know but I'm OCD about this kinda thing, the hole there would just niggle at me.
-
- 2.0 HDI 110
- Posts: 9656
- Joined: Tue Jun 01, 2010 5:42 pm
- Location: The Countryside, Northern Ireland
- Contact:
Re: Stalk blanking plate
it would niggle me also.
Re: Stalk blanking plate
Get anice peice of plastic similar colour and make one,
Imade a blanking plate when iremoved the stalk when ihad a 306,
ilooked for ages to find one which made me go for the Blue peter route
Imade a blanking plate when iremoved the stalk when ihad a 306,
ilooked for ages to find one which made me go for the Blue peter route

-
- 2.0 HDI 110
- Posts: 9656
- Joined: Tue Jun 01, 2010 5:42 pm
- Location: The Countryside, Northern Ireland
- Contact:
Re: Stalk blanking plate
A few possibilities:
- use some expanding foam, put some in the hole, let it dry, sand it down and paint the area black.
- Tape over the hole, then put some fibreglass filler on the other side.
-
- use some expanding foam, put some in the hole, let it dry, sand it down and paint the area black.
- Tape over the hole, then put some fibreglass filler on the other side.
-