Another immobiliser Problem

iando · Post by **iando** » Tue May 08, 2007 4:55 pm

My sri turbo immob works fine when punching in the code manual,but I cant get it to go into auto mode,done everything it says in the handbook,get all the beeps but when I lock it and open it and try to start its back to manual.

Any ideas

robessex · Post by **robessex** » Sun May 13, 2007 12:22 pm

I have got exactly the same problem on my SRI turbo

unfortunately now mine wont start at all.
You can try James suggestion, that is with the engine running drop the fuse box flap and disconnected the ribbon D plug that goes into the back of the keypad. This means the immob is permanently disabled unless you get a flat battery. If this happens reconnect and enter pin until then you dont need to enter pin.

I know this does not solve the problem of why it will not retain pin but at least you dont have to enter the number all the time. If you find the real answer please let us all know!

Robessex

Benner · Post by **Benner** » Mon May 14, 2007 11:23 am

I couldn't do it either.

I'm assuming that you are doing the C1C sequence? The problem I had was that my C didn't beep when I pressed it so I assume I have a connection problem.