Rear Window Isolator Switch

[averagejo]

Hi all,

Does anyone know the pin out of this switch and how I can by pass it?

Reason being is the rear passengers cannot use the window controls whether the isolator is pressed or not - but im still able to operate their windows from the drivers controls so i was looking to pop this switch out and cross the wires to always enable them just to determine if the isolator switch is the problem or not.

thanks

dan

[HimBigChief]

Ooh, if you get me then +12V pins for the connector on your drivers switch, then I shall work through and let you know what you'd need to do to get it sorted.

[steve_earwig]

Ooh, if you get me then +12V pins for the connector on your drivers switch

Do you mean these?

Btw I had the switch apart 'cos it looked a bit grubby. Then I put it back together again sharpish

[HimBigChief]

Yes, awesome! Much gracias senor! I spotted your reply while I was at work, but it must have blocked the picture as that mever showed up on the work comp. Right, that's this evening's joib then!

[averagejo]

thanks

[HimBigChief]

From what I've worked out so far it looks like the wire which is in pin 8 on the 16 pin connector on the back of the switch.

[averagejo]

From what I've worked out so far it looks like the wire which is in pin 8 on the 16 pin connector on the back of the switch.

so basically liven up pin 8 with one of the +12v pins and that should overide the rear window isolator (just so im sure )

dan

[HimBigChief]

Worth a try. Just give it a quick check first by bridging the pins to check that nothing shorts and then you can't blame me for breaking your car!

[averagejo]

damn, i was hoping you were working some new for old scheme